THERMOBILE Bio Energy - US Manuel De L'utilisateur page 14

English
Fault Cause
The flame goes 9 There is insufficient supply of
out directly after combustion air
ignition.
10 There is no proper flue draught. Check whether the flue is fitted according
11 The flue draught is too high or
irregular.
12 The flue draught is too low.
13 The maximum thermostat is not
installed properly or defective.
14 The overflow protection is filled
with biodiesel or vegetable oil.
The fuel pump
does not run and
the control light
is off, while the
heater is pre-
heated and the
switch is
switched to "1"
or "2".
The flame is
extinguished
while the fuel
pump is still
running.
The heater 15 There is too much biodiesel or
makes a vegetable oil at start up.
humming sound.
There is soot
formation in the
combustion
chamber and in
the flue.
There is unburnt 16 There is too much biodiesel or
fuel on the vegetable oil at start up.
burner dish.
Record the maintenance details in table A in the
14
Solution
Check the functioning of the combustion
air fan.
to the description, see "flue".
Check the flue for leakage.
Clean the flue if necessary.
Position a flue stack valve, see "flue".
Adjust the flue to the right draught (see
maintenance table 5.1) with the
counterweight on the valve (fig. 7).
Check all connections in the flue.
Reduce the number of bends.
Heighten the flue.
Isolate the flue outside the building.
Check the flue, see "flue".
Reset the thermostat, see fig. 3(Q).
Replace the thermostat, see fig. 3(Q).
Clean the overflow protection dish, the
burner dish and the floor of the vaporiser.
See faults: 3, 6, and 14.
See faults: 2, 5, 7, 9, 10 and 12.
Reduce the amount of biodiesel or
vegetable oil.
See faults: 10, 11, and 12.
See faults: 8, 9, 10, 11 and 12.
Reduce the amount of biodiesel or
vegetable oil.
See faults: 8, 9, 10, 11 and 12.
appendix of this booklet.
40.020.952 - rev. 04 - 2011
Action
Dealer
User
User
User
Dealer
User
User
User
User
User
User
Dealer
User
User
Bio Energy - US