Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Fault
The flame goes out
directly after ignition.
The heater makes a
16 There is too much diesel
humming sound.
There is unburnt fuel
on the burner dish.
Record the maintenance details in table A in
the appendix of this manual.
7
SPARE PARTS
Before use we advise you to have spare parts
in store, see table B in the appendix of this
manual.
AT 400 - 500-US series
Cause
The flue draught is too
low.
oil at start up.
8
•
9
9.1
The heater has a flue stack connection.
1. Push a T-piece (A) directly over the
2. Push the flue pipe (C) on the T-piece.
3. Use three screws to screw the flue pipe
•
•
•
•
40.020.943 - rev. 04 - 2011
Solution
Isolate the flue outside the
building.
Check the flue, see "flue".
Reduce the amount of diesel
oil.
Low temperatures for single
walled flue, for instance in
case of frost.
The sound will stop when the
temperature rises.
See faults: 2, 11, 12, 13 and
14.
TECHNICAL INFORMATION
See for technical specifications table C in
the appendix of this manual.
INSTALLING ACCESSORIES
Flue (fig. 12)
connection (B).
to the T-piece.
Caution
The flue must meet the following
requirements.
The flue must be pointed upwards.
The flue (or any part of it) may not be
positioned horizontally. A 45° angle is
acceptable.
It is not allowed to lenghten the flue
connection horizontally.
When a pipe is used under 45°, pipe
pieces of at least 3.2 ft must be fitted in
front of and at the back of the slanting
pipe.
English
Action
User
User
User
User
17
Publicité
Table des Matières
