Spare Parts; Technical Information; Installing Accessories; Eu Declaration Of Conformity - THERMOBILE GA42 Manuel De L'utilisateur

7

SPARE PARTS

Contact the dealer for the use of spare parts.
8

TECHNICAL INFORMATION

• For technical specifications, see table B
in the annex at the back of this manual.
• For the electrical circuit diagram, refer to
diagram C in the annex at the back of this
manual.
8.1 Explanation of the electrical circuit
diagram
/i
Pos. Description
I Ionisation pin
O Ignition pin
T Ignition transformer
MT Maximum thermostat
MV Magnetic valve
S Switch
RT Room thermostat
BA Burner automat
M Motor
L Indicator lamp
C1 Condenser
C2 Condenser
RC RC circuit
V Heating element
9

INSTALLING ACCESSORIES

9.1 Outside air suction set (fig. 12)
When a hose with a wall feed-through is
used, the combustion air can enter directly
from outside.
1. Make a hole in the wall to place the wall
feed-through (A).
2. Slide one end of the hose (B) onto the
inlet of the heater (C).
The air hose may have a maximum
length of 6 m.
GA 42-60-85-110
3. Slide the other end onto the connection
of the wall feed-through (D).
4. Fix the hose at both ends with hose
clamps.
9.2
The connection to the heater has a diameter
of 100 mm.
10
THERMOBILE INDUSTRIES B.V.,
Konijnenberg 80, NL-4825 BD BREDA,
assume full responsibility when declaring that
products:
PROPANE GAS-FIRED AIR HEATERS GA
42, GA 60, GA 85 and GA 110
meet the following EU directives:
Machine directive: 98/37/EEC
Low voltage directive: 72/23/EEC
EMC directive: 89/336/EEC
The Netherlands, Breda,
01-05-2005
R.E. Merkenhof
Managing Director
40.020.947 - rev. 01 - 2007
Connection diameter of air hose
EU DECLARATION OF
CONFORMITY
English
25