Mounting The Wings - Reely Wild Hawk Notice D'emploi

i) Mounting the wings
• Slide the right part of the wing (1) from the right into the
prepared slot in the fuselage until it snaps in place.
• Then the wing connection pipe is slid into the round
boring in the wing (2).
• Then attach the left part of the wing on the wing
connection pipe and also slide it into the fuselage until
it snaps into place.
As the fit of the wings with the wing connection pipe and the wing opening on the fuselage is very tight,
you do not need to additionally secure the wings. This lets you quickly disassemble the model for
transport purposes.
• If the borings in the wings widen over time, apply a strip of adhesive tape on the wing connection pipe to secure the
parts again.
48
Figure 15