Reely Wild Hawk Notice D'emploi page 46

If you pull the control stick for the elevator and the fin unit to the left, the fin unit must deflect to the left. This pushes the
landing gear to the right in flight and the model will roll around the longitudinal axis to the left due to the changed flow
situation on the wings.
You have to slightly pull on the elevator so that the model does not loose any height in this slanted position.
If the elevator unit deflects to the right, you can reverse the rotation direction of the fin servo with the reserve switch for
the fin unit (see ill. 2, pos. 7).
If you pull the control stick for the elevator and the fin unit to the right, the fin unit must deflect to the right. This pushes
the landing gear to the left in flight and the model will roll around the longitudinal axis to the right due to the changed
flow situation on the wings.
You have to slightly pull on the elevator so that the model does not loose any height in this slanted position.
After completing the test, first turn off the model and then the transmitter; remove the flight battery from the model.
46
Figure 12
Figure 13