HHB CDR-850 Mode D'emploi page 28

A
DIGITAL
OUTPUT
OPTICAL COAXIAL
R L R
AES
/EBU
DIGITAL IN BALANCED IN BALANCED OUT
DIGITAL IN DIGITAL OUT LINE IN
R L
OPTICAL COAXIAL OPTICAL COAXIAL
S/PDIF S/PDIF
DIGITAL IN DIGITAL OUT
OPTICAL COAXIAL OPTICAL COAXIAL
S/PDIF S/PDIF
DIGITAL
C
B
OPTICAL
28
<PRE1282>
En
CDR-850
L
PARALLEL
AC IN
REMOTE
LINE OUT
SIGNAL
GND
R L
D
OUTPUT
INPUT
C
COAXIAL
CONNECTION WITH OTHER EQUIPMENT
7 Digital signal connections.
(Before connecting this unit with other units please
remove the power connection to this unit.)
This unit features both optical and coaxial digital input and
output sockets, allowing flexibility for various connection
situations. The active input is selected from the front panel
switch, the outputs are both active, therefore either or both
can be used.
A
Connect the digital input socket of the unit to the digital
output of the source device, such as a CD player. Use
either optical or coaxial connection. When making optical
connections, align the connector carefully with the socket
and insert fully into the socket.
B
Connect either the optical or coaxial digital output socket
of the unit to the digital input of an external device such as,
a mixer, DAT or MD recorder. Never use both the optical
and coaxial connectors together to the same device, but
both outputs may be used to two different devices.
C
For coaxial digital connections use Phono/RCA type
connectors with 75 Ω cable for correct impedance. Avoid
the use of standard phono interconnection cables for
digital signals, as they are not usually of the correct
impedance and may cause signal degradation.
D
After completing connections with other equipment
please ensure the power connection to the unit is
reconnected.