Display Message List - HHB CDR-850 Mode D'emploi

DISPLAY MESSAGE LIST

When the words in the messages are listed separately in quotation marks, they are displayed alternately.
Message
"OPEN"
"CLOSE"
"SET" "UP"
"TOC" "READ"
"1-SYNC"
"AL-SYNC"
"CANNOT" "SYNC"
"MONI"
"INPUT" "CD"
(MD, DAT, DCC, DVD)
"PMA REC"
"TRACK?"
"SKIP" "SET?"
"SKIP" "CLEAR?"
"LAST", "TRACK",
"ERASE?"
"TOC" "ERASE?"
"ALL", "TRACK",
"ERASE?"
"ALL", "DISC",
"ERASE?"
"STAND BY"
"20 --:--"
"UnLOCK"
In addition to the above, other messages are displayed if the unit detects faulty operation during use.
For messages not listed above, refer to "Self-diagnostics" on page 118.
112
<PRE1282>
En En
Description
The CD tray is being opened.
The CD tray is being closed.
The unit is performing initial calibration for recording. Please wait.
The unit is reading the TOC (Table Of Contents) from the disc. Please wait.
The unit is standing by for 1-track synchro digital recording. The recording will
start synchronized to the track start of the player.
The unit is standing by for all-track synchro digital recording. The recordings will
start synchronized to the track starts of the player.
This will be displayed when the input selector is not set for digital optical or
coaxial input, or when the format of the digital input is not CD, MD, DAT or DCC.
The unit is monitoring the selected input, as set on the INPUT SELECTOR.
The unit displays the source it is monitoring (for CD, MD, DAT, DVD or DCC).
Temporary TOC data is being recorded to the discs PMA (Program Memory
Area). Never turn off the power when this is displayed.
Appears during the track programming operation to prompt for track number
input.
Appears during the track skip setting operation, to confirm the creation of a skip
ID. If you want to skip a track, select the track with the SKIP ID SET button.
Appears during the track skip clear operation, to confirm the clearing of a skip ID.
If you want to clear the skip designation of a track, select the track with the SKIP
ID CLEAR button.
Erases the last track.
If you want to erase the last track, press the 8 (PAUSE) button.
Erases the TOC information on the CD-RW disc. If you want to erase the TOC,
press the 8 button.
Erases all tracks.
If you want to erase all tracks, press the 8 (PAUSE) button.
Erases the entire disc (initializing the disc).
If you want to erase the entire disc, press the 8 (PAUSE) button.
A record mode button has been selected before the unit is ready to enter a
record mode. Please wait.
The source signal that is being input cannot be digitally recorded. Recording will
stop, creating an empty track.
The digital input is selected, but the connections are not correct, or the digital
signal is not being output from the source device. Please check all cabling, and
source device status.
Reference page(s)
44
44
54
58
54, 58, 60
48
48
54, 60, 62, 64,
74
106
82
84
90
90
92
92
54
54
28