HHB CDR-850 Mode D'emploi page 30

A
Turn and remove
Tournez et retirez
Gire y quite
B
Pull out.
Tirez.
Saque.
C
Wall outlet
Prise murale
Toma de corriente
Figure is for U.S.A. model.
La figure illustre le modèle de l'appareil conçu pour les Etats-Unis.
La figura pertenece al modelo de los EE.UU.
30
<PRE1282>
En
Cap
Capuchon
Tapa
Cap
Capuchon
Tapa
Power plug
Fiche d'alimentation
Clavija de alimentación
CONNECTION WITH OTHER EQUIPMENT
7 Caution in the use of fibre optic cables.
÷ Do not bend an optical cable at too sharp an angle
(minimum radius 7.5 cm [3 inches]). Be especially careful
when mounting the unit in a rack if the optical cables are
already connected. When an optical cable is stored in the
form of a loop, the loop should have a diameter larger than
15 cm [6 inches].
÷ An optical cable must be inserted completely into the
socket, loss of signal could occur with the cable not fully
inserted.
÷ Use optical cables with a length of no more than 3 meters
[10 feet].
÷ Be careful not to leave dust on or scratch the ends of
optical cables. If the plugs are dirty wipe gently with soft
lint free cloth before connection.
÷ When the optical sockets on the unit are not being used
protect the sockets with the supplied dust caps.
A
Digital input/output coaxial socket caps.
÷ Remove the black dust cap before using the coaxial
digital sockets.
÷ Be sure to replace the dust cap when not using the
coaxial sockets.
B
Optical sockets are delicate !
÷ Remove the dust caps from the optical sockets before
use, and be sure to replace the caps when the sockets
are not being used.
÷ Retain the dust caps when the optical sockets are in
use.
C
Connection of the power cord.
÷ Connect the correct end of the supplied power cord to
the unit and the other end to a suitable AC outlet.
÷ Make sure that both connectors are fully inserted.