Mettler Toledo IND560x Guide D'installation page 47

4. Mark the position of the mounting holes on the vertical surface per the dimensions shown in
3-8 METTLER TOLEDO IND560x Terminal Installation Manual
B. Loosen and remove the two nuts securing the two grounding straps (that also operate as
hinges for the front cover) to the rear housing (Figure 3-11).
Figure 3-11: Loosening the Ground Straps
C. Carefully rotate the front cover 180 degrees and reattach the two grounding straps to the
two studs on the opposite side of the housing shown in Figure 3-12, near the grip
bushings using the two nuts removed in the previous step. Tighten the two nuts.
Figure 3-12: Additional Studs for Alternative Attachment of Cover
Figure 3-13 or by holding the terminal up to the surface and marking through the bracket
holes. Dimensions are provided in inches and [mm].
Figure 3-13: Wall Bracket Mounting Hole Pattern
Nut
Grounding
strap
316061929 | 12 | 01/2019