Fiber Optic Interface - Mettler Toledo IND560x Guide D'installation

3. On the harsh enclosure terminal, after all the cables have been connected, tighten the
3.4.4.

Fiber Optic Interface

An optional fiber optic interface board provides communication to an ACM500, a legacy dual
channel fiber optic converter located in a safe area, or to an IND560x used as a remote display
inside the hazardous area or the safe area. The fiber optic interface option can be ordered already
installed into the IND560x at the factory or is available as a kit that can be installed in the field.
Instructions are included with the kit showing the installation procedure of the option into the
IND560x terminal as shown in Figure 3-42.
The interface board provides two dedicated circuits for communication to the ACM500 or the two
circuits can be used to communicate with the dual channel fiber optic converter as two independent
ports. A single channel can be used to talk to an IND560x remote display.
When the scale type of the IND560 is "Remote" (refer to Chapter 3, Configuration), a single Fiber
Optic channel can also be used to receive communication from a Puma or ID3sTx terminal, making
the IND560x a remote terminal for a Puma or ID3stx.
316061929 | 12 | 01/2019
IND560x COM5 (J3)
Table 3-15: Wiring to IND226x as a Remote Display
IND560x COM4 (J4)
compression nuts on the cable glands to secure the cables.
ACM200 COM (J3)
Terminal #
3
4
IND226x Interface-
Remote PCB COM4 (J4)
Terminal #
1
2
3
4
Figure 3-42: Fiber Optic Interface Board
METTLER TOLEDO IND560x Terminal Installation Manual
Terminal #
3
4
Terminal #
1
2
3
4
3-33