Gecko Aeware in.clear Mode D'emploi page 25

keypad operations
Boost key
The first press of the Boost key
turns the in.clear ON and puts the
in.clear into maintenance mode.
ON appears on the keypad
display.
Press and hold the Boost key
for 2 seconds to turn in.clear OFF.
OFF will appear on the keypad
display.
With the system in Maintenance
Mode, press the Boost key to
activate the Boost Mode.
Note: The Boost mode should
be activated every time you use
your spa.
24
The keypad display will show a
numeric value that corresponds
to the selected level. There are
8 possible levels available with
the Boost Mode.
As a rule of thumb, the Boost
level corresponds to the number
of bathers using the spa.
Set the Boost level by using the
up and down arrow to
select the number of bathers that
use the spa (i.e., husband and
wife = 2, and so on).
Confirm the selection by pressing
the Boost key again or wait
5 seconds for the system to save
the desired level and activate the
Boost Mode cycle.
Note: In.clear keeps your boost
level in memory.
in.clear
Press the Boost key during
a Boost cycle will cancel the
remainder of that Boost cycle
and return the in.clear system to
maintenance mode.
The Bromine Generation
Indicator (LED), located above
the Boost key, lights up when the
cell is producing bromine and is
OFF when no bromine is being
produced.
Note: The Bromine Generation
Indicator will blink if the in.clear
system cannot generate bromine
due to low or no water flow.
™