Getting Started (See Video); Start-Up Procedure - Gecko Aeware in.clear Mode D'emploi

getting started
Start up procedure:
(see video: www.geckoal.com/inclear)
1 - Draining and cleaning the spa
It's important to completely drain and clean the spa to remove
all residues accumulated on the surface and inside or around the
jets area. After draining the spa, use spa cleaning products only.
Household cleaners contain additives such as phosphates which
may affect the bromine production. When the spa is clean, rinse it
off thoroughly with a garden hose.
It's extremely important to clean your filter cartridge with a
filter soaking solution or replace your filter cartridges.
It is important that the spa is well cleaned and rinsed prior to the startup
of the new system. Some biofilms may have formed in the spa that
could prevent the system from functionning properly. We strongly
recommend the use of a flushing product such as Spa System Flush,
Swirl Away or National Chemistry Spa Purge to clean the plumbing
even if the spa is brand new.
18
2 - Refilling the spa
After the in.clear unit has been installed, check the TDS
(Total Dissolved Solids) of the water you'll use to refill the spa.
The TDS range should be within 50 and 400 PPM. Verifying the TDS
range can be done by your local spa dealer. When you're certain
the water is within the proper TDS range, refill your spa.
If your TDS is higher than 500 PPM, ask your spa dealer for
additional information to help reduce initial TDS.
DO NOT use water from a "Salt Water Softener" system.
Make sure there is adequate flow and that no airlocks are trapped
in the unit's plumbing. If airlocks are formed, start the pump and
slowly loosen one of the union nuts to release the air trapped in the
plumbing. Tighten the nut again after you are done.
in.clear
™