Skirt Mount Installation - Gecko Aeware in.clear Mode D'emploi

keypad installation

Skirt mount installation

For a skirt mount installation the keypad should be installed directly
on a spa panel so that it is easily accessible to the user.Insure that
the keypad control is located accordingly.
Drill from the finished side of the spa to prevent chipping
of the surface. Start by pilot drilling the hole centers using a 3 mm
(1/8") drill bit. Using the appropriate hole saw slowly drill two
25 mm (1") diameter holes at 67 mm (2 5/8") from center to center
as illustrated.
10
Cut out the material between the two holes (see illustration above).
Clean the installation surface and route the keypad cable from the wall
cutout to the in.clear unit. (Continues on next page).
in.clear
™