Gecko Aeware in.clear Mode D'emploi page 12

in.clear
™
∅ 25 mm
(1")
Skirt mount installation
Peel the adhesive gasket from the
back of the keypad, insert it in
the cutout and align it correctly,
then ensure it's properly glued
by gently pressing evenly on the
entire surface.
Gasket with
adhesive
If the keypad is equipped with
an optional holder plate remove
the two wing nuts in the back
of the keypad and remove the
mounting bracket.
Insert the keypad into opening
you have cut out. Put the
mounting bracket and the wing
nuts back on their respective
bolts and fix the keypad securely
in place (see illustration above).
Note: It is the installer's responsibility to ensure that no obstructions
(cables, piping, etc.) are present below the deck at the drill hole
location.
Note: If the installation location is not perfectly even (e.g. wood
surface), make a silicone joint between the installation location and the
back of the unit to ensure a proper seal around it.
keypad installation
11