Other Tips - Gecko Aeware in.clear Mode D'emploi

getting started
7 - Determining the Boost Mode level for my spa
Every time you use your spa, activate the Boost Mode using the
Boost Key on the keypad. As a rule of thumb, the Boost level
may correspond to the number of bathers using the spa. For
example, activate the Boost level to 2 indicators if two (2) bathers
are entering the spa.
At the end of the Boost period, verify that the bromine level has
returned to the 3-5 PPM range. If the bromine level is too low or too
high after the Boost period, the Boost level should be adjusted the
next time the spa is used. For example, if bromine level is higher
than 5 PPM after Boost, lower the Boost level by one at next use
under the same conditions. Repeat these steps until you are able to
determine the ideal Boost level for your usage.
Note: Boost levels depend on the number of bathers using the
spa. We recommend you validate the Boost level after each use
to determine the ideal Boost level for every condition (number of
bathers).
22

Other tips:

For Canada, in.clear must only be used with sodium bromide (such
as BromiCharge) scheduled or registered under the Pest Control
Product Act. For USA, the sodium bromide (such as BromiCharge)
must be registered under EPA.
Your warranty will be void if product other than sodium is bromine
is used as a substitute.
Do not breathe it or get into your eyes! First Aid
instructions should appear on the sodium bromide container.
Do not use any other sanitation chemicals (including
shock) other than sodium bromide in the spa.
When adding fresh water to the spa, start a Boost to help build
a residual bromine bank.
in.clear
™