Gecko Aeware in.clear Mode D'emploi page 17

installation
Gecko
# 52202000
www.geckodepot.com
Use adapters to connect the
in.clear system to 3/4" tubing or
directly to 2" tubing.
For an optimal connection to
spa plumbing, please note
that we recommend the these
compression fittings & nuts.
Gecko
# 0699-300007
www.geckodepot.com
16
Slide the two plastic union nuts
over the in.clear unit's threaded
ends and tighten the nuts.
Hand tighten!
Do not use tools!
Power cable
In.clear must be pro-
tected by the same
ground fault interrupter
(GFCI) circuit as the spa
system.
A blinking "AC" message
on the keypad means that
the input signal is not
240 VAC, probably 120 VAC.
Please check connection.
in.clear
Connect the in.k200 keypad to
the unit (see keypad installation
section of this manual for more
details).
™