Special Functions - Migatronic OMEGA3 YARD 300 Guide De L'utilisateur

Special functions

1. Open menu
4. Set parameter
Parameters and menu selection
Press and hold the -key to open the user menu. Turn the
left control knob until the desired menu is displayed. Use
the right control knob to alter settings displayed in the right
display. Press the -key briefly to activate functions, such as
gas test.
Functions and parameters in the user menu:
Press the -key to exit the menu
GAS test
Press the -key to open and close the gas valve. If
an IGC kit is installed, it is possible to adjust the gas flow with
the right control knob.
IGC status and calibration
Visible only if IGC kit is installed.
Press the -key to start IGC calibration.
Use the right control knob to switch between manual and
synergic gas control if a synergic MIG program is selected:
0: Manual gas control
1: Synergic (IGC) gas control
2. Find menu selection
5 secs
5. Save selected data
Exit menu
Gas test
IGC status and calibration
(not all models)
Remote control
Options menu for machine settings
(not all models)
Setting remote control
Use the right control knob to change the following
settings (Basic panel only 0-2):
0: Disabled
1: Dialog torch (item no. 80100402)
2: Analogue remote control (item no. 78815029)
4: MIG-A-Twist V2 (November 2010) (item no. 80100403)
5: MIG-A-Twist V1 (item no. 80100403)
6: ERGO2 1–7 sequences (item no. 80100774)
7: ERGO XMA 1–3 sequences (item no. 80100758)
Options menu for machine settings
(Applies only to the Pulse and Synergic panels)
Press the
return to the main menu.
Long Cable Compensation - status and
calibration
Press the
Use the right control knob to enable/disable Long
Cable Compensation:
0: Disabled
1: Enabled
16
3. Select menu point
6. Exit menu
-key to exit the OPt-menu and
-key to start cable calibration.