Migatronic OMEGA3 YARD 300 Guide De L'utilisateur page 15

Connection and start-up
Manual gas adjustment
(optional equipment)
Max. setting = the valve is open
Manual gas adjustment
Switch on, press, weld
Setting the welding program
• Switch on the welding machine on the main switch
(2).
• Select welding program or material/gas/wire
A V
61111425
BASIC III
• Adjust welding current and
secondary parameters.
For more information
about setting the
parameters, please refer to
the quick guide
• The machine is ready to
weld
WARNING
When you activate the torch trigger,
there is voltage applied to the
welding wire and electrode.
Software reading
• Insert the SD card into the
machine's card reader as
shown in the drawing.
• Turn on the machine.
• The display flashes briefly
with three lines when up-
date starts.
• Wait until the set current is
displayed.
• Turn off the machine and remove the SD card.
• The machine is ready for use.
In case of exchange of the control unit, software must
be loaded onto the new control unit by means of an SD
card. Software can be downloaded at
www.migatronic.com
15
dimension (depending on
model).