Special Functions - Migatronic SIGMA2 300 Compact Manuel D'instruction

Display of software version
Software versions can be displayed during start-up.
Keep the key pressed during start-up. When the
key is released, use the right control knob to switch
between the following displays:
1: Wire feed unit software version
2: Welding program package version
3: Power source software version
®
4: MIG Manager software version
5: Robot Interface software version
6: RoboFeeder 1 software version
7: RoboFeeder 2 software version
8: Serial number for control panel
Press the key at the right-hand side of the right control
knob to return to default display mode, and welding
can start.
Special configuration of internal/external
control
Press the key briefly to switch between internal
and external control. The indicator above the key is
switched on/flashes, when external control has been
selected.
Configuration:
Press the key for > 5 seconds to get the following
options (MIG/MAG):
1 = Dialog torch (factory setting)
2 = ERGO 3 sequence torch.
Model XMA
(not possible in Basic control
panel)
Article no.: 80100758
3 = Remote control
4 = ERGO 1-7 sequence torch.
(not possible in Basic control
panel)
Article no.: 80100774
®
5 = MIG Manager
6 = MIG-A TWIST 1-7 sequence
torch version 1 (sold until
November 2010)
7 = MIG-A TWIST 1-7 sequence
torch version 2 (sold from
November 2010)
Article no.: 80100403
Turn the right control knob until the requested number
is shown. Press the key at the right-hand side of the
right control knob or the
All manuals and user guides at all-guides.com

SPECIAL FUNCTIONS

key to accept the number.
In MMA it is only possible to connect a remote control,
so this is automatically selected when external control
is selected.
Dialog torch:
Current/wire feed speed/material thickness can be
adjusted both on the left control knob on the control
panel and on the torch control dial.
Voltage trim/voltage/arc-adjust can be adjusted from
the right control knob on the control panel.
Sequence torch:
Selecting sequence torch (external control)
automatically defines 3/7 sequences that can only be
changed on the torch. All other settings can be carried
out on the control panel.
IMPORTANT!
It is not possible to switch between sequence numbers
1-7 (1-3 for the ERGO model XMA) if the wrong
sequence torch has been selected. Please select a
suitable type from the list.
Remote control:
Current/wire feed speed/material thickness can be
adjusted both on the left control knob on the control
panel and on the remote control dial.
Voltage/arc-adjust can be adjusted both on the right
control knob on the control panel and on the remote
control dial.
Voltage trim can only be adjusted on the remote
control.
®
MIG Manager :
Please refer to the MIG Manager
Lock function (option)
When a Migatronic lock card has been inserted into an
unlocked control panel, the left display shows
and the right display shows
Simultaneously, the lock symbol
The key lock function has three levels. At level 1, only
the advanced functions are locked:
- Secondary parameters
- Program selection
- Change of max. number of sequences
- Error log
- Torch configuration
- Water cooling configuration
- Pulse
- DuoPLUS
22
®
quick guide.
, or .
illuminates.