Special Functions - Migatronic SIGMA2 300 Compact Manuel D'instruction

Display of software version
Software versions can be displayed during start-up by
keeping the -key pad pressed. When the key pad
is released, it is possible to change between display of
1: Wire feed unit software version
2: Welding program package version
3: Power source software version
®
4: MIG Manager software version
5: Robot Interface software version
6: RoboFeeder 1 software version
7: RoboFeeder 2 software version
8: Serial number for control panel
by means of the right control knob. A press on the key
next to the right control knob returns to normal display
mode and welding can start.
Special configuration of Internal/external
control
A short pressure on the keypad changes
between internal and external control. The indicator
above the knob is switched on/flashes, when external
control has been selected.
Configuration:
The following possibilities (MIG/MAG) can be selected
after a long pressure (> 5 secs.) on the
1 = Dialog torch (factory setting)
2 = 3-sequence torch
(not possible in Basic control panel)
3 = Remote control
4 = 7-sequence torch
(not possible in Basic control panel)
®
5 = MIG Manager
Turn on the right control knob until the requested
number is shown. Press on the key next to the right
control knob or on the
then accepted.
In MMA it is only possible to connect a remote control,
so this is automatically selected when external control
is activated.
Dialog torch:
Current/wire feed speed/material thickness can be
adjusted both on the left control knob internally and on
the control wheel on the welding torch.
Voltage trim/voltage/arc-adjust can be adjusted from
the right control knob on the control panel.
Sequence torch:
3/7 sequences are automatically defined when
selecting external control. Change of sequences can
only be carried out from the torch. All other settings
are carried out internally on the control panel.

SPECIAL FUNCTIONS

-keypad.
-keypad and the number is
Remote control:
Current/wire feed speed/material thickness can be
adjusted both on the left control knob internally and
from the control knob on the remote control.
Voltage/arc-adjust can be adjusted both from the right
control knob internally and from the control knob on
the remote control.
Voltage trim can only be adjusted from the remote
control.
®
MIG Manager :
Read quick guide for MIG Manager
Lock function (option)
Left displays shows
when a Migatronic lock card has been inserted.
Simultaneously, the lock symbol
The key lock function has two levels. At level 1, only
the advanced functions are locked:
- Secondary parameters
- Program selection
- Change in number of sequences
- Error log
- Torch configuration
- Water cooling configuration
- Pulse
- DuoPLUS
Change of level is possible by turning the right control
knob until is displayed. Level 2 is accepted by
pressing the right control knob and remove the card.
At level 2, the same functions as at level 1 are locked
and besides this the following:
- Current / wire feed speed / plate thickness
- Trim voltage / voltage / arc-adjust
- Tack ON/OFF
- 4-times ON/OFF
Even though the machine is locked, it will always be
possible to control the machine from a robot interface
and to use the functions:
- Inching
- Gas test
- Change of sequence (both from panel and
trigger).
The control panel is unlocked by reinserting the
Migatronic lock card. The lock symbol
turned off.
24
®
and right display
illuminates.
is then
or