Warranty Conditions; Warranty Regulations - Migatronic FLEX 2 3000 Compact Manuel D'instruction

Error codes for Power control package 10001703.cry
Error code Cause and solution
The file 10001703.cry has an error.
1. Insert the SD card in the machine
again.
2. Exchange the SD card.
SD card is not formatted.

The SD card must be formatted in a
PC as FAT. Or use another SD card.
The software does not match this
control unit.

Use a SD card with software that
matches your control unit.
DSP-PCB is defective

Contact MIGATRONIC Service
Data transmission error

Turn on and off the machine.
Exchange the SD card if the error is
displayed again. Contact your dealer
if necessary.
The file 10001703.cry has an error.
1. Insert the SD card in the machine
again.
2. Exchange the SD card.
DSP-PCB is defective

Contact MIGATRONIC Service
The SD card contains too many files
with 10001703.cry-data
SERVICE
Test
Test functions which should only be used by the
service technician in connection with troubleshooting
of the machine.
The following test can be carried out:
- Turn on cooling unit
- Turn on fan
- Turn on magnetic valve
- Turn on wire feed motor
The following information can be displayed:
- Power source temperature
- DC link voltage
- IAC module installed

WARRANTY CONDITIONS

Migatronic (which is hereinafter referred to as "the
Supplier") continuously carries out quality control
throughout the manufacturing process as well as
check of the complete units through comprehensive
testing.
The Supplier provides warranty in accordance with the
following provisions, by correcting errors and defects
on units, that demonstrably and within the warranty
period may have been caused by faulty material or
workmanship.
The warranty period is 24 months for new welding
machines, 12 months for new accessories and 6
months for spare parts. The warranty period is
calculated from the date of invoice to the end user
from the Supplier or the Supplier's dealer/distributor.
The original invoice is proof of the warranty period.
The warranty period is 12 months or maximum 1,800
operating hours for the CoWelder solution. The
warranty period is calculated from the date of invoice
to the end user from the Supplier or the Supplier's
dealer/distributor. The original invoice is proof of the
warranty period.
The warranty period is 24 months for new welding
machines incorporated in robotic, automated and
CoWelder solutions. The warranty period is calculated
from the date of invoice to the end user from the
Supplier or the Supplier's dealer/distributor. The
original invoice is proof of the warranty period.
The warranty period can be extended to up to 60
months on selected parts by registration at
www.migatronic.com of new welding machines not
later than 30 days after the date of purchase. The
following welding machines fall within the scope of the
extended warranty: Automig, Automig-i, MIGx series,
Sigma Select series, Omega series, Sigma series,
Sigma Galaxy, Pi series, Pi Plasma, Zeta.
Welding torches and intermediary cables are
considered as wearing parts, and only errors and
defects found within 12 months upon delivery and due
to faulty material or workmanship, will be considered
under warranty.
Warranty repairs neither extend nor renew the
warranty period.
Any transport of goods or persons in connection with a
warranty claim is not covered under the Supplier's
warranty obligation and will therefore be at the buyer's
expense and risk.
You can read the complete Warranty Conditions at
www.migatronic.com
25