Brew Group Cleaning - Gaggia Milano Accademia Mode D'emploi

40
CleaninG

BreW GroUP CleaninG

Wash the brew group at least once a week. Before removing the group, remove the used grounds drawer as shown in fi g. 2 on page 38.
Wash the brew group with lukewarm water.
Lubricate the brew group after approximately 500 brewing cycles. The brew group lubricant may be purchased from an authorized service
center .
WARNING! Do not wash the brew group with detergents that may compromise its correct operation. Do not wash it in the
dishwasher.
1
Press the PUSH button to remove the
brew group.
4
Apply the lubricant evenly on both side
guides .
7
The lever on the rear part of the group
must be in contact with the group
base .
2
Wash the brew group and the fi lter and
dry .
5
Make sure the brew group is in rest
position; the two references must match.
8
Insert the washed and dried brew group.
DO NOT PRESS THE "PUSH" BUTTON .
3
Lubricate the brew group guides using
the supplied lubricant .
6
Make sure the components are in the
correct position. The hook shown must
be in the correct position; to check its
position, fi rmly press the " PUSH" button.
9
Insert the used grounds drawer
and close the service door .