Gaggia Milano Accademia Mode D'emploi page 52

44
maCHine WarninGS
Help Message Displayed
ROTATE THE MILK CARAFE
DISPENSING SPOUT INTO
BREWING POSITION
ROTATE THE MILK CARAFE
DISPENSING SPOUT INTO
RINSING POSITION
PLACE MILK CARAFE
IN ITS HOUSING
15/01/10
10:38
15/01/10
10:38
RESTART TO SOLVE
THE PROBLEM
E XX
How to Reset the Message
A beverage with milk has been selected. The machine requires the carafe
handle spout to be placed into dispensing position .
Press the button "ESC" to cancel the selection.
The carafe rinse function has been selected .
Press the button "ESC" to cancel the selection.
The selected operation requires the milk container for brewing. Insert the
container in the machine as specifi ed in the manual.
Press the button "ESC" to cancel the selection.
Perform a descaling cycle on the machine .
When this message is displayed, it is still possible to use the machine, but
its correct operation might be compromised .
Damages caused by failure to descale the machine are not covered by
warranty.
The machine requests the "Intenza" water fi lter to be replaced with a
new one. Replace the fi lter as described on page 7.
The alarm is displayed only if the "Filter Enable" function is set to "ON".
(See page 30) .
Flashing red light . Machine in Stand-by .
The Stand-by settings can be changed .
Press the " " button.
An event has occurred which requires the machine restart. Take note of
the code (E xx) shown at the bottom.
Switch off the machine, wait 30 seconds and then switch it on again. If
the problem persists, contact the service centre .