Brew Group - Gaggia Milano BRERA Sup 037RG Mode D'emploi

Reassemble the external part of the
Pannarello.
• We recommend cleaning the water
tank daily. For an easier removal of the
water tank, move the steam wand /
Pannarello upwards:
- Remove the small white filter in the
- Reposition the small white filter in
- Fill the water tank with fresh drinking
• Empty and clean the drip tray daily.
Perform this operation also when the
float is raised.
• Also clean the seat of the tray every
week through the openings on the
bottom of the machine.

Brew Group

• The brew group should be cleaned
every time the coffee bean hopper is
filled or at least once a week.
• Turn off the machine by pressing the
ON/OFF button and remove the plug
from the socket.
• Remove the coffee grounds drawer.
Open the service door.
• To remove the brew group, pull it by
the handle and press the «PUSH» but-
ton. The brew group must be washed
only with lukewarm water with no
detergent/soap.
4219-465-04361 GAG. MAN. BRERA US EN-ES-PT Rev 00.indd 21
water tank and wash it under running
drinking water.
its housing by gently pressing and
turning it at the same time.
water.
• Wash the brew group with lukewarm
water and carefully clean the upper
filter.
• Thoroughly wash and dry all the parts
of the brew group.
• Thoroughly clean the inside of the
machine.
• Make sure that the two reference signs
match up.
• Make sure that the lever is in contact
with the brew group. Press the "PUSH"
button to make sure that the brew
group is in the correct position.
Lubricate the brew group af-
ter approximately 500 brew-
ing cycles. The grease to lubricate
the brew group may be purchased at
authorised service centres.
• Lubricate the brew group guides using
the supplied grease only.
• Apply the grease evenly on both side
guides.
• Insert the brew group in its seat until it
locks into place WITHOUT pressing the
"PUSH" button.
• Insert the coffee grounds drawer. Close
the service door.
• 21 •
15/10/2020 12:06:30