Stand-By Mode - Gaggia Milano Accademia Mode D'emploi

Stand-BY mode

The machine is designed for energy saving . After 60 minutes of inactivity, the machine goes into stand-by mode, the boiler is no longer
heated and all the devices turn off .
Power consumption is reduced to a minimum. Press any button to turn the machine on again.
The machine status can be manually changed to stand-by mode by holding the stand-by button pressed for 3 seconds .
Note:
1 The stand-by mode cannot be activated if the service door is left open.
2 The stand-by activation time can be changed in the "MACHINE MENU" on
page 28.
3 When the stand-by mode is activated, the machine performs a rinse cycle
of the internal circuits. It is possible to interrupt the cycle by pressing the
"STOP" button.
The machine can be turned on again by executing one of the following actions:
1 By pressing any of the control panel buttons .
2 By opening the service door (when closing the door the machine goes back to
stand-by mode) .
3 If a pre-set timer becomes active .
A
The button becomes red and blinks when
the machine is in stand-by mode .
11