Hold-Up Function; How To Enable The Hold-Up Function; Disarming From Keypad Under Hol-Up; Hold-Up Indication - Elkron MP500/4N Mode D'emploi

1.10

HOLD-UP FUNCTION

1.10.1

How to enable the hold-up function

On , MP500/8 and MP500/16 control panels, starting from control panel SW version 1.01 and
MP500/4N
version 1.03, has been added the option to enable or disable the hold-up function for all the user codes already enabled or that will be
enabled later.
Proceed as follows to set the hold-up function:
1) Enter <Installer code >, press
2) Press repeatedly until SETTINGS appears.
3) Press and then
4) Press and then
5) Press .
6) Use and to select enable or disable. Press
7) Press repeatedly to exit from the menu.
MPORTANT! Enabling the hold-up function will cancel EN50131 compliance.
1.10.2

Disarming from keypad under hol-up

On , MP500/8 and MP500/16 control panels, starting from control panel SW version 1.01, if the hold-up function has been
MP500/4N
enabled and you are threatened and forced by a criminal with the risk of life then, you can disarm the burglar system while arming the
hold-up alarm simultaneously which will make the dialer sending the programmed alarm messages without activating the siren sound.
To disarm the system when your are under coercion, just increase your user code of one digit. For example if your user code is 000021
you need only to enter 000022; if user code is 29 enter 30, if it is 39 enter 40, etc.
IMPORTANT! Enabling the hold-up function will cancel EN50131 compliance.
1.10.3

Hold-up indication

This is an indication that the user can trip when forced by an assailant to disarm the system. It is always active (H24), but can be
temporarily deactivated by setting the system to maintenance status.
This is generated
when...
It activates...
It is stored...
It lasts...
It is stopped by...
and then .
several times until USERS appears.
several times until HOLD UP appears.
•
A hold-up input is opened.
•
hold-up user code is entered
The alarm is generated regardless of partition status (H24).
•
The programmed hold-up outputs which have at least one partition in common with the input or with the
entered access code.
•
The dialler to send the respective hold-up in progress alarm message (if programmed) in form of
numeric code, vocal call or modem communication.
•
In the Event Log and the Diagnose Log.
•
For a fixed time of 30 seconds.
•
Entering a valid code on a keypad which has at least one partition in common.
•
Inserting a valid key which has at least one partition in common.
•
Imparting a disarm partition command from the key input.
•
Imparting a disarm command from remote control which has at least one partition in common.
to confirm.
MP500/4N-8-16
starting from
keypad SW
UT00:INSTALLER
SETTINGS
SETTINGS
USERS
USERS
HOLD UP
HOLD UP
ENABLE
MP500/16
12/01/2014 10:10
47