Led Indications With Operating Mode "0; How To View System Status With Operating Mode "0; How To View Open Inputs With Operating Mode "0 - Elkron MP500/4N Mode D'emploi

1.5

LED INDICATIONS WITH OPERATING MODE "0"

1.5.1

How to view system status with operating mode "0"

The system status is display by the LEDs provided on keypads and readers.
Each user can view the system status detail for the part assigned to them (only the partitions on which the user is authorised to operate
will appear).
To view the system status:
1) Enter <Master / User / Installer / Technical Manager code>, press
2) Press . The graphic systems corresponding to digits 1 to 16 appear on the second line of the
screen. The meanings are:
□ = the partition is disarmed
0
= the partition is disarmed with one or more open inputs
■ = the partition is armed
.
= the partition was not programmed
3) Press and to go from one partition to the next. The partition name will appear on the first line.
4) Press repeatedly to exit the menu after examining the status.
If operating mode "0" has been selected, partitions status can be displayed permanently instead of Date-Time.
1.5.2

How to view open inputs with operating mode "0"

The presence of one or more open inputs is indicated by the specific LED on the keypad and by the reader LED.
These LEDs also indicate the opening of isolated inputs.
To view input addresses you can proceed in two ways:
Without entering a valid code: in this case the open inputs viewed are those which have at least one partition in common with the
keypad being operated.
1) Press the MENU key and then press
2) Press . The inputs are identified as "<Logical address>:<Name>" on the second line. For
example, an input to which the kitchen detector is connected with logical address "3" and named
"Kitchen" will be identified as "In003:Kitchen".
3) Use and to scroll the list of open inputs.
4) Press and to see the input customisation.
5) Press repeatedly to exit from the menu after examining the list.
Entering a valid code: in this case the open inputs viewed are those which have at least one partition in common with the keypad being
operated and the valid code entered.
1) Enter <Master / User / Installer / Technical Manager code>, press
repeatedly until OPEN INPUTS appears.
2) Press . The inputs are identified as "<Logical address>:<Name>" on the second line. For
example, an input to which the kitchen detector is connected with logical address "3" and named
"Kitchen" will be identified as "In003:Kitchen".
3) Use and to scroll the list of open inputs.
4) Press and to see the input customisation.
5) Press repeatedly to exit from the menu after examining the list.
32
repeatedly until OPEN INPUTS appears.
MP500/4N-8-16
and then .
twice and then press
UT01:MASTER
SYSTEM STATUS
SE01:...
□□0□■...
MP500/16
12/01/2014 10:10
SYSTEM STATUS
OPEN INPUTS
OPEN INPUTS
In001:...
MP500/16
12/01/2014 10:10
UT02:...
OPEN INPUTS
OPEN INPUTS
In001:...
MP500/16
12/01/2014 10:10