How To Delete The Fault Memory With Operating Mode "0; Partial Reset - Elkron MP500/4N Mode D'emploi

1.6.6

How to delete the fault memory with operating mode "0"

Fault memory is deleted automatically at next arming of the partitions associated to the fault, or manually directly from the menu.
To delete fault memory manually from the menu proceed as follows:
1) Enter <Master / User / Installer / Technical Manager code>, press
2) Press . The fault LED will blink.
3) Use and to scroll the list of faults.
4) He following after examining the list:
5) Press to delete the Tampers Memory.
6) Press repeatedly to exit from the menu after examining the list.
1.7

PARTIAL RESET

The partial reset procedure returns the factory settings of all devices in the system, including the control panel, to default.
Starting from control panel SW version V1.01, the partial reset procedure returns the system to a default setting consistent with the
selected operating mode, i.e. if operating mode 3 or 2 is selected the control panel is returned to factory settings compliant with
EN50131 grade 3-2 (see Programming manual MP500/4N-8-16 - paragraph "Factory settings"), while if operating mode "0" is selected
the control panel is returned to factory settings (see paragraph 1.8 - Factory settings not EN50131 compliant).
It is important to note that codes, keys and event log are not deleted.
Proceed as follows to carry out the partial reset:
1) Enter <Installer code>, press
appears.
2) Press and then
3) Press .
4) Press to confirm the operation. Press
sound during the operation.
5) The first page of the maintenance menu will appear at the end. Press
the menu.
, then and finally
several times until PARTIAL RESET appears.
to cancel the operation. The keypad buzzer will
twice.
repeatedly until MAINTENANCE
repeatedly to exit from
MP500/4N-8-16
UT02:...
FAULT
LOW BATTERY
CONTROL PANEL
FAILURE
DELETE MEMORY?
MP500/16
12/01/2014 10:10
UT00:INSTALLER
MAINTENANCE
MAINTENANCE
PARTIAL RESET
PARTIAL RESET
ARE YOU SURE?
PARTIAL RESET
IN PROGRESS...
37