Maintenance; Battery Refresh - NSK ENDO-MATE DT2 Mode D'emploi

Maintenance

7
7 – 1

Battery refresh

Nickel-metal-hydrate battery may result in a decrease in charging capacity, if additional charging
(repeating a cycle of short-time use and recharging) is made� (Generally, this phenomenon is called a
"memory effect�") This Battery Refresh function is to resolve this phenomenon�
1
Turn off the control unit�
2
Connect the AC adaptor and confirm that the
AC IN lamp lights up�
3
Press and hold the POWER key for more than
1 second, while pressing the REVERSE key�
4
The alarm sounds for a length of time, and
the refresh mode is activated� At this time,
the charge indicator on the LCD display is
animated in the direction opposite to display
at the time of charging� At the same time, the
CHARGE lamp flashes slowly�
5
Leave it as it is� The battery is discharged
and recharged automatically�
Press and hold the POWER key for a while, when you want to stop this process� (At this time, the power
does not turn on�)
● This function is not activated unless this product is powered by the AC adaptor�
● It takes about maximum of 5 hours to discharge the battery�
● It takes 5 hours to discharge and 5 hours to recharge� Therefore, total of about 10 hours are
required�
● This function is not required for each charging� Try this function, if the operating time is shortened
even if the battery is relatively new�
● Do not repeat activation and deactivation of the refresh mode in a short time� It may result in
enhancement of the memory effect�
● This function is fully effective for solution of the "memory effect�" However, it cannot be solved
completely at one time due to characteristics of the battery� We recommend you repeat this
process a few times as necessary�
4/D
1/A
A: ON OFF
B: Illuminated
C: Press and hold simultaneously for 1
second or longer�
D: Flash
NOTICE
30
2/B
3/C