Attaching Barrier Film; Connecting And Disconnecting The Motor - NSK ENDO-MATE DT2 Mode D'emploi

● Do not connect with an outlet that does not match specifications� Doing so may cause a
malfunction�
● Since the AC IN lamp lights to indicate that the supply power is on, it does not go out even after a
charge is completed� See the CHARGE lamp to check the charging conditions�
● The charging normally takes approximately 5 hours, but it depends on the battery use conditions,
age of the battery, air temperature, and other factors�
● The temperature of the battery is measured during charging� Proper charging cannot be
preformed if the charger is placed in an environment which is subject to sharp temperature
change (next to window, subject to direct sunlight, near air outlet or fan heater)� Place it in a place
where temperature change is minimal�
● The charging may not be started in the following cases�
– The temperature of a battery is too low or too high� (less than 0°C or more than 40°C� )
– When the battery voltage is high enough (This does not mean that the battery is fully charged�)
– A battery is not connected
– The voltage of a battery is abnormal (See "8 – 1 Error code"�)
● Battery is automatically charged depending on conditions, even when the power is on� But when
the motor handpiece is used, charging is suspended to protect the battery�
4 – 3

Attaching barrier film

Apply disposable barrier film to a surface where you touch it, such as keys of the control unit, in order to
prevent cross contamination during use�
4 – 4 Connecting and disconnecting the motor handpiece
Connecting
1
Attach the disposable barrier sleeve to the
motor handpiece (including the cord plug)
and secure the end of the motor side of the
barrier sleeve with the barrier film�
CAUTION
13
Preparation for Use