NSK ENDO-MATE DT2 Mode D'emploi page 45

EMC Information (Electromagnetic Compatibility Information)
Cables and
accessories
Motor handpiece cord
AC adaptor
Recommended separation distances between portable and mobile RF communications equipment and the
ENDO-MATE DT2
The ENDO-MATE DT2 is intended for use in an electromagnetic environment in which radiated RF disturbances are
controlled� The customer or the user of the ENDO-MATE DT2 can help prevent electromagnetic interference by
maintaining a minimum distance between portable and mobile RF communications equipment (transmitters) and
the ENDO-MATE DT2 as recommended below, according to the maximum output power of the communications
equipment�
Rated maximum output
power of transmitter
W
0�01
0�1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in
meters (m) can be estimated using the equation applicable to the frequency of the transmitter, where P is the
maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer�
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies�
NOTE 2 These guidelines may not apply in all situations� Electromagnetic propagation is affected by absorption
and reflection from structures, objects and people�
Maximum Complies with
length
1�5 m RF emissions, CISPR11,
Plug side : 1�8m Harmonic emissions,
Unit side : 1�8m Voltage fluctuations/ flicker emission
Electrostatic discharge (ESD)
Surge
Voltage dips, short interruptions and
voltage variations on power supply input
lines
Power frequency (50/60Hz) magnetic field
Conducted RF
Radiated RF
Separation distance according to frequency of transmitter
150 kHz to 80 MHz
d = 1�2 √ P
0�12
0�38
1�2
3�8
12
80 MHz to 800 MHz
d = 1�2 √ P
0�12
0�38
1�2
3�8
12
44
Class B/ Group 1
IEC61000-3-2, Class A
IEC61000-3-3
IEC61000-4-2
IEC61000-4-5
IEC61000-4-11
IEC61000-4-8
IEC61000-4-6
IEC61000-4-3
800 MHz to 2�5 GHz
d = 1�2 √ P
0�23
0�73
2�3
7�3
23