Programs; Alarm Sound Volume Control - NSK ENDO-MATE DT2 Mode D'emploi

5 – 3

Programs

The settings (rotation speed, torque limit value, gear ratio, auto reverse mode) can be memorized in the
selected program number�
1
Select a program number�
2
Adjust the rotation speed, torque limit value,
gear ratio and auto reverse mode by each
key according to your needs�
3
Memorize setting (Memorizing is complete
when long beep sounds)�
● The program cannot be memorized while the motor handpiece is in motion or when the rotation
direction is set to the reverse rotation�
● The rotation direction is not memorized in the program�
● Settings will not be memorized unless the MEMORY key is held down for 1 second or longer�
Settings will not change if the program number is changed with the PROGRAM key without
pressing the MEMORY key�

Alarm sound volume control

5 – 4
The alarm sound volume can be controlled at three steps of "Volume high, Volume low and Limited off� "
(Default setting: Volume high)
1
Press and hold the PROGRAM keys ( ,
simultaneously for 1 second or longer�
2
The alarm mark on the LCD display changes,
and the sound volume changes�
3
Release the PROGRAM key when the sound
volume reaches your required level and the
required sound level is set up�
● The sound level is retained, even if the power is turned off�
● If "5 – 5 Initialization of program (factory-set configuration)" is executed, the sound is set to
"Volume high�"
NOTICE
)
LCD display
A: Press and hold simultaneously for 1
second or longer�
NOTICE
21
Operation Procedure
2
1
3
1/A