Commissioning; Safety Instructions - Burkert 8400 Manuel Utilisateur

Commissioning

8. commissioninG
8.1.

safety instructions

Warning
danger due to nonconforming commissioning.
Nonconforming commissioning could lead to injuries and damage
the device and its surroundings.
• Before commissioning, make sure that the staff in charge have
read and fully understood the contents of the manual.
• In particular, observe the safety recommendations and intended
use.
• The device/installation must only be commissioned by suitably
trained staff.
noTe
Risk of damage to the device due to the environment
• Protect this device against electromagnetic interference,
ultraviolet rays and, when installed outdoors, the effects of the
climatic conditions.
• When the device is switched on and the cover is open,
protection against electric shock is no longer guaranteed.
• Check the chemical compatibility between the fluid to
be measured and the materials from which the device is
made exposed to it
Type 8400
When switching on transmitters only, the display briefly
shows " " when the device's main board and the
BUS RUN
expansion board are synchronised.
english
21