Installation Onto The Pipe - Burkert 8400 Manuel Utilisateur

7.2.

installation onto the pipe

danger
Risk of injury due to high pressure in the installation
• Stop the circulation of fluid and depressurize the pipes before
loosening the process connections.
Risk of injury due to high fluid temperatures.
• Use safety gloves to handle the device.
• Stop the circulation of fluid and depressurize the pipes before
loosening the process connections.
Risk of injury due to the nature of the fluid.
• Respect the regulations on accident prevention and safety relat-
ing to the use of aggressive fluids.
→
Choose a standard G 1/2", NPT 1/2" or Rc 1/2" connection
(depending on the port connection of your device) to install the
device onto the pipe.
Always ensure a watertight seal between the device and
the pipe by following the instructions below.
→
Install the connection on the pipe according to the installation
instructions provided with the connection.
→
For versions with G 1/2'' port con-
nection, ensure that the O-ring is in
place on the device.
→
Replace it if necessary.
Fig. 4: Location of the O-ring on a version with G 1/2" port
connection
14
english
Type 8400
Installationandwiring
do not use its housing to screw the device onto the
pipe.
→
Using an appropriate tool, screw the device
into the connection.
Fig. 5: Installation of the device on the connection
When repositioning the housing, do not unscrew the
metal part of the device from the pipe.
→
After positioning the housing, put the cover
back in its initial position.
ENTER O
U
T 0....9
Fig. 6: Final position of the housing cover