GYS PACK PRO Mode D'emploi page 9

Translation of the original instructions
• Protect the electrical contacts of the battery against short-cir-
cuiting.
Acid projection hazard!
• Wear safety goggles and protective gloves
• If your eyes or skin come into contact with battery acid, rinse
the affected part of the body with plenty of water and seek
immediate medical assistance.
Connection / disconnection:
• Disconnect the power supply before connecting/disconnect-
ing the device to/from the battery
• The terminal of the battery that is not connected to the car
frame must be connected first. The other connection must be
made on the car frame, far from the battery and the fuel
line. The battery charger must be connected to the power
supply network.
• After the charging process, disconnect the battery charger
from the power supply network and remove the connector
from the car frame and then the connector from the battery,
in this order.
Connection:
• Class II device (charger booster)
• Class III device (booster)
• Connection to the mains must be made according to the
national installation regulations.
Maintenance:
• The power supply cable cannot be replaced. If the cable is
damaged,the device should not be used.
• Service should be performed by a qualified person
• Warning! Always remove the power plug from the wall sock-
et before carrying out any work on the device.
• Regularly take off the cover and remove dust with an air gun.
Take the opportunity to have a qualified person check the
electrical connections with an insulated tool.
• Under no circumstances should solvents or other aggressive
cleaning agents be used.
• Clean the device's surfaces with a soft, dry cloth.
Regulations:
• The device complies with European Directive.
• The certificate of compliance is available on our website.
• EAC conformity mark (Eurasian Economic Commission)
GYSPACK PRO EN
9