Yamaha VX700F Manuel D'atelier page 48

1
1
COOLING SYSTEM
4. Remove:
•
Coolant filler cap 1
WARNING
Do not remove the coolant filler cap 1 when the
engine is hot. Pressurized scalding hot fluid and
steam may be blown out, which could cause
serious injury. When the engine has cooled, place
a thick rag or a towel over the coolant filler cap.
SCH2120
Slowly turn the cap counterclockwise until it
stop. This allows any residual pressure to es-
cape. When the hissing sound has stopped, press
down on the cap while turning it counterclock-
wise to remove it.
5. Place an open container under the coolant drain
bolt 1.
6. Remove:
•
Coolant drain bolt
•
Gasket (coolant drain bolt)
7. Drain the coolant.
NOTE:
Lift up the tail of the machine to drain the coolant.
SCH2130
8. Remove:
•
Right side cover 1 (MM700)
SCH2140
2-7
INSP
ADJ