Storage; Troubleshooting - Enarco ENAR ZEN Manuel D'instructions

7.13 STORAGE

When storing the plate for a long period of time:
7.13.1.
7.13.2.
7.13.3.

7.14 TROUBLESHOOTING

PETROL ENGINE
Does not start:
Zero power:
VIBRATING PLATES
Completely empty the fuel from the tank, the fuel pipe and the carburettor.
Remove the spark plug and pour a few drops of oil into the cylinder. Turn the engine
several times by hand so that the oil spreads over the inner surface of the cylinder.
Clean the outer surface of the machine with a cloth soaked in oil. Cover the unit and keep
it out of the damp and in a dust-free environment.
- There is fuel but the spark plug does not spark
 There is electricity in the high-voltage cable

There is electricity in the high-voltage cable

Bridged ignitor plug

Carbon deposit in ignitor plug

Short circuit due to faulty insulation of ignitor plug

Electrodes separated incorrectly
 There is no electricity in the high-voltage cable

Short circuited stop button switch

Faulty ignition coil

Condenser insulation faulty or short-circuited

Ignition coil broken or short-circuited
 Satisfactory compression

Incorrect fuel

Water or dust has got in

Faulty air filter
- There is fuel and the ignitor plug sparks

Faulty compression

Inlet or outlet valve stuck or faulty

Piston ring or cylinder worn

Cylinder head or ignitor plug incorrectly adjusted

Cylinder head gasket or ignitor plug gasket faulty

Clutch locked making the vibrator turn when trying to start

There is no fuel in the carburettor

Fuel tank empty

Fuel cock not open properly

Fuel filter blocked

Air vent in tank cover blocked

Air retained in pipe

Carburettor inlet valve stuck
- Insufficient power

Normal compression and no ignition failure observed
ZEN / ZEN-E
en
27