Inspection; Periodic Maintenance; Storage; Transportation - Enarco VET Manuel D'instructions

4.6 INSPECTION

1. Before starting the job, check the correct working of all handling and safety devices.
2. Inspect regularly the good conditions of the feeding cables.
3. Inspect regularly the connection voltage.
4. If defects are found in the safety devices or other defects which could reduce the safe handling of
the equipment, notify immediately the proper responsible person.

4.7 PERIODIC MAINTENANCE

1. Only an expert shall work on the electrical parts.
2. Make sure that the current is off during repairs.
3. In all maintenance operations, original parts will be used.
4. A periodic lubrication of the motor bearings is not necessary.
5. The electrical earth wire (green-yellow) should be longer to avoid being the first one in cutting in
case of breaking of wires. After maintenance, control the current through the earth cable .
6. Periodically clean the motor housing to prevent overheating.
7. After maintenance job and service, all safety devices should be assembled correctly.
en
8. After working 40 hours inspect the frame holding bolts.
9. Every 12 months or more frequently, depending on the usage conditions, it is recommended an
inspection be done by an authorized dealer.

4.8 STORAGE

When the vibrator has not been used for long periods of time, it should always be stored in clean,
dry, and protected areas.

4.9 TRANSPORTATION

When transporting by vehicles, ensure the converter is safe against slipping, overturning and blows.
MONO-PHASE AND THREE-PHASE EXTERNAL VIBRATORS
VET VEM
8