Storage; Transportation; Waste Disposal - Enarco VIB-BAR E-BATT Manuel D'instructions

5.
6.
7.
8.

7.2 STORAGE

1.
2.
en
3.
4.
5.
6.

7.3 TRANSPORTATION

1.
2.
3.

7.4 WASTE DISPOSAL

1.
2.
3.
VIB-BAR E-BATT – FLEXIBLE SHAFT AND POKER
ABP38
10
TBP0.5m / VIB-BAR
grease penetrates into the poker, or overforces the motor. Do not clean the flexible shaft with
solvent. Ask the manufacturer the type of grease that must be used.
Every 300 hours of working is recommended to clean the poker. To clean the poker dismount
the cap. Hold the housing on a vise and tap the cap with a hammer. This will help to break the
seal and to loosen the threads. Clean the cap and cones with a solvent and fix again with Loctite
243 or equivalent. If rests of grease are inside change the gaskets following point 5.
To do maintenance follows the following steps:
- Flush the parts with solvent and wipe all part. It is very important to keep the cones clean.
- Examine bearing and seals. If inspection reveals that grease of transmission has
penetrated into the head, the oil seals must be replaced. When replacing the seals, mount them
in the same direction (neoprene seal lips must face the hose side).
- The purpose of the seals is to keep the flexible shaft grease out from the poker. Be careful
not to damage the polished surface where the seals are assembled. Once the seals are
dismounted it is recommended to replace them.
- Apply sealant before assembling and fix the O-ring. Tighten and clean the excess of
sealant. It is important that all the parts are tightened to avoid water and concrete get into the
head.
After maintenance works and service, all the parts must be assembled correctly.
Every 12 months or more frequently, depending on the usage conditions, it is recommended to
make an inspection by an authorized dealer.
Always store the screed clean, in dry and protected areas, when it is not used for a long time.
To prevent corrosion occurs, store the batteries in a place with relative humidity less than 80%.
Store batteries at a distance greater than 2.5m from other dangerous substances.
Store batteries separate from metal products.
Store the batteries at a temperature between 5 and 25ºC.
If the batteries are stored for a long time, they must be in a dry place at the specified
temperature and they must be fully charged every 3 months.
During transportation, the screed must be ensured against slipping, overturning and bumps.
Batteries are governed by a specific standard for packaging and transport, with restrictions in
some cases, especially in cases of air transport. Respect these rules depending on the means
of transport used.
To pack and transport the charger, do not fold the cables, roll them up without forcing them.
Disposal of the battery must be done through your dealer, the manufacturer or at the battery
waste management points designated for this purpose. The seller and the manufacturer are
obliged to collect the battery and to arrange its proper recycling or disposal.
NEVER dispose of the battery as if it were household waste, it may cause serious damage to
the environment
Proceed to recycle the rest of the electrical and mechanical components according to the
current regulations for each type of waste in your country.