Maintenance; Maintenance Calendar - Enarco ENAR ZEN Manuel D'instructions

7

MAINTENANCE

7.1

MAINTENANCE CALENDAR

Intervals
Once a day
or every 8
hours
After first 20
hours
Once a week
or every 50
hours
Monthly or
every 250
hours
Once every
six months
or every 500
hours
Once a year
or every
1000 hours
VIBRATING PLATES
Maintenance
area
- Check oil level
Motor
- Inspect air filter
-
Hatz motor
- Check for damage, leaks, or similar problems
Machine
- Clean underside of vibrating plate.
- Change engine oil
- Check threaded connections
Motor
- Clean air filter
- Check and adjust valve clearance
Hatz motor
- Inspect and adjust V-belt
Machine
- Check threaded connections
Motor
- Cleaning cooling system
- Inspect rubber buffers
- Check oil level for vibrator
Machine
- Inspect and adjust V-belt
-
- Change engine oil
Motor
-
- Clean grating on exhaust
Hatz motor
- Check and adjust valve clearance
- Clean sediment bowl
Honda / Robin motor
- Inspect spark plug
- Check and tighten up screws
Machine - Hydraulic control: check level and top up as
-
- Change fuel filtration element
Hatz motor
-
- Check and adjust setting for carburettor
- Inspect and adjust valve clearance
Honda / Robin motor
- Change vibrator oil
- Clean oil filter
Hatz motor
- Clean combustion chamber
- Clean fuel tank and filter
Honda / Robin motor
- Inspect fuel pipe
- Remove dirt and used grease and replace rusty
Machine
Maintenance tasks
Check water separator
necessary.
components
Point
ZEN / ZEN-E
7.4
7.3
7.4
7.3
7.10
en
7.12
7.4
7.7
7.2
7.8
7.6
7.12
7.9
17