Regular Maintenance; Storage; Transportation - Enarco M38AFP Manuel D'instructions

4.4 REGULAR MAINTENANCE

1.
2.
3.
4.
recommended. An expert should dismantle the vibrating poker. Clean with solvent the bearings and
when this is dry fill in with the oil recommended (107512 spare part). If you note an excessive play in
the bearings proceed to change it. When you reassemble place the sealant in all the threads (PTFE
tape). It is important all the parts are tighten (200 to 400 Nm of torque) to avoid the water does not
penetrate in the head. Finally, apply two weld spots to secure the parts do not loose. Test working
10 minutes on the air and check no leak of oil (no touch after the test it is very hot).
5.
watertight.
6.
7.
be done by an authorised dealer.
8.
the housing or cap when the diameter or length in the least point is less than the specified in the
table according to the model.
Model
M38 AFP
en M5 AFP
M6 AFP
M7 AFP
M8 AFP
a.
b.
c.
d.

4.5 STORAGE

Store the vibrating pokers in clean, dry and protected areas when it is not used for long periods.

4.6 TRANSPORTATION

When transporting by vehicles, be sure the equipment is safe against slipping, overturning and
blows.
8
M38 AFP-M5 AFP-M6 AFP-M7 AFP-M8 AFP
MP38 AFP-MP5 AFP-MP6 AFP-MP7 AFP
Only an expert shall work on the electrical parts.
Disconnect the vibrating poker of the converter before doing any maintenance
In all maintenance operations, original parts will be used.
Every 24 months or 500 hours of working a lubrication of the bearings of the vibrating pokers is
Always you change the switch be sure the bolts of the switch box are tighten and the box is
After maintenance jobs all the parts must be assembled correctly.
Every 24 months or more frequently, depending on the use, it is recommended an inspection
Check the wear of the poker controlling the outside diameter and length of the poker. Replace
Diameter(mm) Length (mm)
36,5 (38)
48 (50)
56 (58)
63 (65)
75 (73)
The minimum dimensions are bold printed
The dimensions into brackets are the original dimensions
Replace the housing when reach the minimum diameter
Replace the cap when reach the minimum length
365 (370)
360 (365)
371 (376)
351 (356)
378 (383)
ELECTRIC VIBRATING POKERS