Cleaning The Oil Filter (Hatz Motor) - Enarco ENAR ZEN Manuel D'instructions

7.9 CLEANING THE OIL FILTER (HATZ MOTOR)

The oil filter should be cleaned at the same time as the oil is changed, since there may be a loss of
oil when this filter is changed.
!
7.9.1.
7.9.2.
7.9.3.
7.9.4.
7.9.5.
7.9.6.
7.9.7.
7.9.8.
7.9.9.
en
24
ZEN / ZEN-E
ATTENTION:

The motor should remain at a standstill and in a horizontal position.

Danger of burns caused by hot oil!

Use current standard procedures for managing the residual oil.
Loosen nut "1" (approximately 5 turns).
Remove the filter from its housing.
Use compressed air from the inside spraying outwards to eliminate dirt from the filter.
Check the state of gasket "1", and replace if damaged.
Check that gasket "2" is in good condition and inserted in the correct position, if
necessary, change the oil filter.
Lubricate the gasket before fitting in position.
Insert the filter and press home.
Make sure that ends "1" of the tension springs are next to the oil filter before tightening
up the nut.
Check the oil level with the dipstick and, if necessary, fill up with oil until it reaches the
MAX level.
VIBRATING PLATES