Storage; Transportation; Locating Malfunctions - Enarco i-SPYDER 38 Manuel D'instructions

Model
M38
M5
M6
M7
M8
a. The minimum dimensions are bold printed
b. The dimensions into brackets are the original dimensions
c. Replace the housing when reach the minimum diameter
d. Replace the cap when reach the minimum length

4.8 STORAGE

When the converter has not been used for long periods of time, it should be stored in clean, dry and protected
areas.

4.9 TRANSPORTATION

When transporting by vehicles, ensure the equipment is safe against slipping, overturning and blow.
5

LOCATING MALFUNCTIONS

With the open lid, check the light is on. Follow the table to identify the problem. During this operation follow
of the safety recommendations.
Make sure that the current is off during repairs.
PROBLEM Internal LED
Not working LED OFF
Red LED ON +
Overcurrent
Yellow LED ON
Yellow LED ON
Leakage current + Green LED
ON
Blue LED ON +
Fail of phase
Green LED ON
The poker is noisy Green LED ON
Green LED ON
The vibrating poker
works correctly
Green LED ON
but it overheats
Diameter(mm) Length (mm)
36,5 (38) 365 (370)
48 (50) 360 (365)
56 (58) 415 (420)
63 (65) 395 (400)
75 (73) 395 (400)
External LED
push button /
pistol
LED OFF
Red LED ON
Yellow LED ON
Red LED
flashing
Green LED ON
Green LED ON
Green LED ON
2V 38, 2V 50, 2V60, 2V70, 1V 38, 1V 50, 1V 60
CAUSE
See if it has power.
Check cord
Check plug
Converter burnt out
Stator poker burnt out
Converter burnt out
Earth leakage current (check poker,
connections)
Water inside converter or poker
Lack of phase in poker (3 phase motor). Check
connections and cables.
Bearings are not in good conditions.
Check the poker is not working out of concrete.
Verify the input voltage of the converter.
Bearings in bad conditions or without
lubrication.
FRECUENCY CONVERTER AND POKERS
en
i-SPYDER
11