Atag HI9071M Manuel D'utilisation page 144

installation
possibilities for building in
attention
installation of the induction hob above a combi-
microwave oven, a 90 cm ATAG oven or an oven of a
different brand
e
e
50
200
GB 30
Ensure that the connection cables hang freely. If there
is a drawer underneath the hob, make sure that the
contents do not project above the edge of the drawer
and interfere with the ventilation.
2
50 cm
e
e
t
r
r
t
r
t
min.
560 x 6 mm
48
Saw out the ventilation opening(s), making sure
that the total surface of the holes is a minimum
of 100 cm . See the drawing, for example,
2
showing 2 holes of 50 cm
Fit a protective plate between the oven and the
hob. The plate should be at least 10 mm thick
and heat-resistant (85 °C). The space between
the underside of the hob and the protective plate
must be at least 50 mm.
To protect the air flow, fit a protective panel
- of the same material as the protective plate -
between the protective plate and the hob.
Ventilation is via the adjoining cupboards.
2 .