General; Safety Instructions; Overall Dimensions - Atag HI9071M Manuel D'utilisation

safety instructions

overall dimensions

Only a qualified electrician should connect the hob to the
mains supply!
The installation should be performed in accordance with the
applicable national and local regulations. Damage caused by
improper installation or connection is not covered by the
guarantee.
For the appliance to work well, it is important:
• That there is sufficient ventilation to allow the hob to cool
down, in accordance with the possibilities specified in this
chapter.
• The ventilation air drawn in by the hob must not be warmer
than 35 °C. Bear this in mind if the oven is to be built in
under the hob.
• That the connecting cable hangs freely and is not caught by
a drawer.
• The worktop is flat.
• If the hob is to be built in any nearer than 40 mm from an
adjacent wall or kitchen cabinet, either to the back or side
of the appliance, the wall or cabinet should be lined with a
heat resistant material.
904
48
860
installation

general

522
490
2
100 cm
GB 27