CAMPAGNOLO Athena 11 Ergopower Power-Shift Mode D'emploi page 14

Make sure that the arrow on the
band faces towards the upper part
of the control unit (C - Fig. 5).
• If the support cover has been com-
pletely removed, moisten the insi-
de slightly with alcohol to facilitate
installation on the control unit.
• Position the Ergopower control in
the curved area of the handlebar and
attempt to create a straight line if the
handlebar bend lets you (Fig. 6).
- The control unit must be correctly
oriented to avoid affecting bicycle
aerodynamics (Fig. 7).
• Secure the control on to the handle-
bar by tightening the screw (B - Fig. 3
- Page 9) to 10 Nm / 7,37 lb.ft using
a torque wrench.
5
C
6
7
NO!
���
OK!
���
NO!
���
26
• If necessary, install the casing
8
retainer clamps (not included
in the pack – available as
spare part, code no. EC-RE001
in aluminium and EC-AT001 in
resin) on the square bosses on
the frame (Fig. 8).
Note
Carbon frames might need special casing retainer clamps, available as spare parts
(in aluminium – code no. EC-RE002).
2 . F I T T I N G T H E D R I V E T R A I N S
• Install the cable guide plate
9
(included in the pack) under
the bottom bracket shell, as
follows:
- position the washer (A – Fig.
9) in the provided seat in the
cable guide plate.
- place the cable guide plate
under the bottom bracket
shell and fix it by means of
the provided screw (B – Fig.
9) with a torque of 3÷4 Nm /
2,21÷2,95 lb.ft using a torque
wrench.
10
.
Different plates can also
give rise to a serious loss
of performance.
• The cable casings of the rear
derailleur (A - Fig. 10) have
a diameter of 4.1 mm, while
Ø 4,1 mm
��������
the brake cable casings (B -
Fig. 10) have a diameter of
4,9 mm.
27
B
A
� �
Ø 4,9 mm
������