CAMPAGNOLO Athena 11 Ergopower Power-Shift Mode D'emploi page 20

NOTE
Ergopower control levers are fitted
™
with a pushbutton (A - Fig. 35) which
holds your brakes in the wide open
position to facilitate wheel maintenan-
ce.
4 . R E M O V A L
• Remove the rear derailleur (or front derailleur) and the brake cables from the
Ergopower control lever.
™
• Raise the support cover (A - Fig. 3 - Page 23) to expose the retaining screw (B
- Fig. 3 - Page 23).
• The Ergopower control lever can be removed leaving the band on the handle-
™
bar, thereby avoiding the need to untape the handlebar.
• Unscrew the securing screw (B - Fig. 3 - Page 23) with a Torx T25 wrench and
lift the Ergopower control lever off the handlebar.
™
35
�
38
5 . M A I N T E N A N C E
• Casings are supplied pre-lubricated and do not require any additional
lubrication.
•Ergopower control levers must be checked by a specialist mechanic every
™
3 years or every 30,000 Km (18,000 miles). The cables and casings must be
replaced every 2 years or after 20,000 Km (12,000 miles).
• In the event of competitive use, Ergopower
by a specialist mechanic and cables and casings must be replaced every year
or every 15,000 Km (9,000 miles).
• Periods and riding distances are purely indicative and may be signifi-
cantly different in relation to conditions of use and the intensity of your
activity (for example: racing, rain, salted Winter roads, weight of the
rider etc.). Check with your mechanic to select a schedule that is best for
you based on your size, riding conditions and you riding style.
• Salt,mud and sand seriously damage bicycles and their components.Thoroughly
rinse, clean and dry your bike after using it in these conditions.
• Never spray your bicycle with water under pressure. Pressurized water, even
from the nozzle of a small garden hose, can pass seals and enter into your
Campagnolo components, damaging them beyond repair. Wash your bicycle
®
and Campagnolo components by wiping them down with water and neutral
®
soap. Dry them using a soft cloth. Never use abrasive or metal pads.
• Relubricate the drivetrains carefully using a lubricant suitable to purpose
• After applying the lubricant move the cranks and engage all possible gear com-
binations in order to thoroughly lubricate the entire drive system.
• Thoroughly clean any residual lubricant from the bicycle and floor.
• At the end of the lubrication operation, CAREFULLY degrease rims and brake
pads.
39
control levers must be checked
™