CAMPAGNOLO Athena 11 Ergopower Power-Shift Mode D'emploi page 13

Control levers
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 30
1 . I N S T A L L A T I O N
CAUTION
The passages of cables of
the type indicated in figure
1 seriously affect the shif-
ting performance of the 11s
drivetrain.
Do not use handlebars with
this type of passages of
cables.
• Ensure that the angle α is suf-
ficiently large to guarantee cor-
rect assembly of the sheath and
the associated smoothness of
the cable (Fig. 2).
• Make sure that the part of the
handlebar onto which you are
fitting the control has a surfa-
ce rough enough to guarantee
maximum adherence.
WARNING!
If the controls are not fitted
correctly they may cause acci-
dents or physical injury.
1
2
α
24
• Raise the support cover (A
3
- Fig. 3) to expose the secu-
ring screw (B - Fig. 3).
• Loosen the screw
(B -
Fig. 1) located on the upper
part of the body, so that the
retaining band (C - Fig. 1)
can be slid over the non-
taped handlebar without
removing the band from
the Ergopower
control
lever unit.
The ergonomics of the new
4
Ergopower
controls can
TM
be adapted for cyclists with
very large hands by ap-
plying an insert (D - Fig. 4).
• Fit the "big hands" insert
into the rear bottom part
D
of the control (Fig. 4) before
installing it on the handle-
bar.
25
��������������
��������������
������������������

Publicité

Table des Matières
loading

Table des Matières