CAMPAGNOLO Athena 11 Ergopower Power-Shift Mode D'emploi page 19

3 . O P E R A T I O N
• Lever A (Fig. 30) controls brake operation.
• Lever B (Fig. 30) on LH control acts on the
front derailleur to raise the chain to the
upper chainring.
• Lever (B - Fig. 30) on LH control acts on
the front derailleur to raise the chain to the
upper chainring. Move lever (B - Fig. 30) on
the LH control by 3 notches to raise the chain
on the front derailleur to upper chainring.
For a triple crankset, repeat the operation to
position the chain on the largest chainring.
• Lever C (Fig. 30) acts in a similar manner on
the front derailleur to lower the chain to the
lower chainring.
• Lever B (Fig. 30) on RH control acts on the
rear derailleur to raise the chain to the upper
sprocket.
• Lever C (Fig. 30) on the RH control acts on
the rear derailleur to lower the chain to the
lower sprocket.
• It is possible to move levers B (Fig. 30)
on the RH control by several consecutive
notches to raise the chain a maximum of
three sprockets in a single movement.
30
�
�
�
36
• Levers (B - Fig. 30) and (C - Fig. 30) can be operated with the hands in
a high (Fig. 31 and Fig. 33) or low position (Fig. 32 and Fig. 34) on the
handlebar.
31
33
37
32
34