Connecting A Universal Sonar Extension Cable - MINN KOTA POWERDRIVE Mode D'emploi

CONNECTING A UNIVERSAL SONAR ExTENSION CABLE

The Universal Sonar Cable may not be long enough to reach the fish finder. If the cable length does not reach the desired fish finder
installation location, a 14.5' extension cable is available. Minn Kota recommends using the MKR-US2-11.
1
a. Place the motor in the stowed position.
b. Locate the Universal Sonar, if equipped, at the base
of the Mount.
c. Locate the Universal Sonar four pin connector at
the end of Universal Sonar Extension Cable. The
connector is black with a stainless steel threaded
locking collar.
NOTICE:
Your fish finder should be turned off until
this procedure is complete.
Four Pin Connector Four Pin Connector
2
d. Align the pins of the Universal Sonar connector plug
from the Control Head with the matching socket end
of the appropriate Universal Sonar Extension Cable
for your fish finder. Firmly push the connector plug
into the socket of the Universal Sonar connection.
Twist the locking collar until it is snug.
e. Connect the other end of your adapter plug to your
fish finder following the manufacturer's instructions.
©2021 Johnson Outdoors Marine Electronics, Inc.
CONNECTING A UNIVERSAL SONAR ExTENSION CABLE
Universal Universal
Sonar Cable Sonar Cable
from Control from Control
Head Head
Universal Sonar Universal Sonar
Extension Cable Extension Cable
Coil Cord Coil Cord
Mount Mount
NOTICE:
If the cable length does not reach the desired
fish finder installation location, a 14.5' extension cable is
available (MKR-US2-11) (sold separately).
Locking Collar Locking Collar
NOTICE:
The connectors are keyed to prevent
reversed installation.
Control Head Control Head
Universal Universal
Sonar Sonar
Four Pin Connector Four Pin Connector
Universal Sonar Cable Universal Sonar Cable
from Control Head from Control Head
minnkotamotors.com | 15